Ryobi One+ Tool Mount for Biltema Pegboard (12mm)

Your Ryobi tools deserve better than a shelf pile. If you've got a Biltema pegboard on the wall — the kind with 12mm spacing and 4mm holes — this mount clips your Ryobi One+ tools flush and secure, right where you can grab them without digging.

The angle is dialled in so your tools sit close to the board, not jutting out awkwardly into the room. That matters in a tight garage or workshop where every centimetre counts.

How it solves the problem

Standard pegboard hooks hold tools loosely. They tilt, fall off, and don't account for the weight distribution of a power tool. This mount is built specifically around the Ryobi One+ form factor, so the tool sits stable, level, and where you put it — every time.

• Designed for Biltema pegboard: 12mm hole spacing, 4mm holes
• Keeps tools flush against the board — no awkward outward angle
• Ryobi One+ compatible fit
• No tools needed to mount or swap tools in and out
• Works with drills, drivers, and other One+ handheld tools

Built for the workshop

Whether you're setting up a dedicated tool wall or just trying to stop your drill from living on the workbench, this mount earns its spot. It's the kind of small upgrade that makes a workshop actually work — everything visible, everything reachable, nothing in the way.

Mount a single one above the workbench, or run a row of them across the board for a full tool wall. Either way, you unbox it, clip it in, and you're done.

Specifications

Design by oleost